Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HiHave followed multiple advise but cannot succesfuly get multicast from outside to inside interface of an asa v 8.2(1)attached the basic config of the asa and mroute - doing me peanut in what am i missing here?The pc on the inside seems to want t...
Guysyes im grey and losing it !Basically im using a basic access-list and a debug command ....eg access-list 101 permit ip any host 11.12.1.1term mondebug ip packet access-list 101If i ping 11.12.1.1 from the router I can see the packets in debug , ...
Hi Is there any limit on nat capabolity on an ASA or is this dependent on ram/ cpu ?I ask as i have 18 nat pools and 18 Global outside addresses ( a subnet per pool going to a single outside address pat / nat ). Each PC connection can have 100 + conn...
HiLooking for some advice re content security on wireless. We are setting up general wireless access for our employees. However this will not touch our corporate network to avoid PCI and purchase of an overall wireless security policy etc ..... this ...
Currently i am deploying a network wide NTP set up. All works fine but we have some confusion over the use of " NTP master "If we do not include the NTP master command on the catalyst cores the NTP set-up does exactly what we expect.When we add NTP m...
HI Guiseppe and allI thought this myself and disabled CEF ( no ip cef ).then when i ping from the router itself i get*Jun 14 08:38:08.168: IP: tableid=0, s=2.1.2.1 (local), d=172.24.33.242 (Serial0/1/0), routed via RIB*Jun 14 08:38:08.168: IP: s=2.1....
no rules here !!we keep all network kit seperate from server equipment as we have two teams , one networks and one PC support and we dont like each other dibbling in each others racks !!!
ASA facing internet says all is fine - i can see connection fine - its a tunnel through to the VPN . The VPN conc has ipsec over tcp 10000 and nat-t highlighted I have tried the client (xp) on both UDP Nat/Pat and tcp 10000 - works fine 4 data ! Thin...
Thanks Andrew but def not routing as i can ping all devices concerned, also not licences as I have enough to sink a battleship.lI get an asn error on cisco mars saying invalid turret id but works fine on local lan