cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1411
Views
15
Helpful
7
Replies

Privilege level information

gerardor884
Level 1
Level 1

does someone knows what is the detail information of privilege levels 0 to 15?

 

what does privilege level 3?

what does privilege level 7?

 what does privilege level 15?

 

I am looking for the most basic level that permits show commands such as show ip route, show ip bgp summary, show cdp neighbors

 

Thanks

2 Accepted Solutions

Accepted Solutions

Francesco Molino
VIP Alumni
VIP Alumni

Hi

Privilege 15 means admin with full rights. Privilege 1 is user-level command only. Everything in between is up to you to configure on the switch to device what privilege can access what command. If you assign privilege 4 and commands for this privilege aren't defined, ios will go to lower privileve until it get one configured. This means, if you didn't configure any privilege and assign level 4 to a user, it will check 3 then 2 and finally 1 and assign level 1 commands to your user.
If you had configured 3, then commands 3 were assigned.
Privilege 0 has only few command.

Take a look here:
https://learningnetwork.cisco.com/docs/DOC-15878

https://www.cisco.com/c/en/us/support/docs/security-vpn/terminal-access-controller-access-control-system-tacacs-/23383-showrun.html


Thanks
Francesco
PS: Please don't forget to rate and select as validated answer if this answered your question

View solution in original post

7 Replies 7

alex it looks like the URL that you just provided is broken

 

Thanks

I just checked the new one and it works.

Francesco Molino
VIP Alumni
VIP Alumni

Hi

Privilege 15 means admin with full rights. Privilege 1 is user-level command only. Everything in between is up to you to configure on the switch to device what privilege can access what command. If you assign privilege 4 and commands for this privilege aren't defined, ios will go to lower privileve until it get one configured. This means, if you didn't configure any privilege and assign level 4 to a user, it will check 3 then 2 and finally 1 and assign level 1 commands to your user.
If you had configured 3, then commands 3 were assigned.
Privilege 0 has only few command.

Take a look here:
https://learningnetwork.cisco.com/docs/DOC-15878

https://www.cisco.com/c/en/us/support/docs/security-vpn/terminal-access-controller-access-control-system-tacacs-/23383-showrun.html


Thanks
Francesco
PS: Please don't forget to rate and select as validated answer if this answered your question

Thank you !

You're welcome

Thanks
Francesco
PS: Please don't forget to rate and select as validated answer if this answered your question