08-21-2014 12:41 AM - edited 03-10-2019 12:16 AM
Hi
I have created a local user ABC on Cisco router with privilege 6 but when I login using ABC and apply enable command then I am able to run any command so my question is
Is the “enable” command after login using user ABC with privilege leve 6 equivalent to level 15 privilege?
username ABC privilege 6 password 0 cisco
SW3#telnet 10.10.10.100
Trying 10.10.10.100 ... Open
User Access Verification
Username: ABC
Password:
SW2#
SW2#enable
Password: xxxxxxxx
SW2#conf t
Enter configuration commands, one per line. End with CNTL/Z.
SW2(config)#
Please advise
08-24-2014 01:06 PM
Can you post:
1. The output of "show privilege" after you enter the enable secret
2. Post the full device config
Thank you for rating helpful posts!
09-18-2014 05:11 AM
yeah I also have this problem... i seem to be able to create multiple user accounts but they all seem to use the same enable secret... which of course has a privilege level of 15...
I need to prevent a certain user from getting into config mode...
any ideas anybody?
Thanks
09-19-2014 12:40 AM
Please post your configs here.
09-20-2014 10:31 AM
I can't because the config is in use on a live switch...
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide