07-25-2006 11:19 AM - edited 03-09-2019 03:42 PM
I've setup basic config on ASA5510 running asa721-k8 and asdm521 via CLI. Now when I access via ASDM the username/password does not work. Any suggestions? I can access via console, telenet and SSH with no problems.
07-25-2006 05:41 PM
Hi .. try leaving both entries blank ..
07-25-2006 08:56 PM
Hi
i think ur looking at it all wrong.. what exactly is the error when u use the asdm.. i guess it just does not let u in..
look at the bottom of the page that is tryin to load the page.. it will read " java security .... (something).. access denied..."
this is due to ur version of java... make sure u have atleast java 1.4.2 upward and try again.. 1.5 works fine.. the problem is that if u go back to access and old pix device.. it will not support 1.4.2 and above.. so that is a more frequent issue..
I hope it helps .. please rate it if it does !!!
Victor
07-26-2006 03:20 AM
I found the problem. I had upgraded ASDM version and forgot to tell ASA about it. Now works with my username/password.
07-26-2006 03:49 AM
so.. how did u tell the ASA about it ?
07-26-2006 06:03 AM
asdm image disk0:/asdm521.bin
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide