Hello everyone
I am using the folloing configuration on Cisco ME36000X for port shaping
policy-map TEST_OUT_10MB
class class-default
shape average 10000000
policy-map TEST_IN_10MB
class class-default
police 10000000
interface GigabitEthernet0/2
switchport trunk allowed vlan none
switchport mode trunk
load-interval 30
service instance 101 ethernet
encapsulation untagged
service-policy input TEST_IN_10MB
service-policy output TEST_OUT_10MB
bridge-domain 101
interface Vlan101
bandwidth 10000
ip address xxx.xxx.xxx.xxx 255.255.255.252
I have applyed also the same port shaping on an Cisco 7609-S with an 7600-ES+20G3CXL
policy-map TEST_10MB
class class-default
police 10000000
shape average 10000000
interface GigabitEthernet1/11
bandwidth 10000
ip address xxx.xxx.xxx.xxx 255.255.255.252
load-interval 30
service-policy input TEST_10MB
service-policy output TEST_10MB
When i am downloading a file and capturing the traffic with wireshark there is significant difference on Cisco 7609-S graph with that one on Cisco ME3600X. Both have the same internet connection.
Is there any way to fine tune Cisco ME3600X to have the same behavior like Cisco 7609-S?
Regards
Antonis.
