Hi all,
Many, many apologies if this is not the right area for this..... I have been working on Cisco gear for many, many years, but have recently been given a project involving some Juniper Equipment (MX240), of which I have to create an LNS across to our wholesaler's LAC.... I have never configured an LNS from Scratch and so the Wholesaler provided some helpful configurations, which are from their Cisco perspective.... I have posted the Cisco code below and was wondering (hopefully) if someone would know the Juniper equivelant commands, or at the least, be able to explain what each line is acheiving (I have searched online to no avail)....
Interface Virtual-Template22
Description xxxxxx
No ip address
Ip tcp adjust-mss 1420
No logging event link-status
Load-interval 30
No peer default ip address
No snmp trap link-status
Ppp authentication chap pap callin
Ppp ipcp ignore-map
Vpdn enable
Vpdn logging
Vpdn-group TTB_THN
Accept-dialin
Protocol l2tp
Virtual-template 22
Terminate-from hostname ldn-vc.thn
Source-ip xxx.xxx.xxx.xxx
Local name TTB_LNS_LHN
Lcp renegotiation always
L2tp tunnel hello 10
L2tp tunnel password xxxx
L2tp tunnel timeout no-session 0
Vpdn-group TTB_HBX
Accept-dialin
Protocol l2tp
Virtual-template 22
Terminate-from hostname ldn-vc.hex
Source-ip xxx.xxx.xxx.xxx
Local name TTB_LNS_HEX
Lcp renegotiation always
L2tp tunnel hello 10
L2tp tunnel password xxxx
L2tp tunnel timeout no-session 0
Thanks in advance