ATTENTION: We are currently working an issue with posting. Thank you for your patience while we work on a resolution.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1118
Views
0
Helpful
1
Replies

High CPU Asr1002 Bras

Fernando Galvao
Level 1
Level 1

 

We are deploying two Bras pppoe licensed to 24,000 sessions each. The problem is that when mass authentication begins to arrive the CPU goes up and it locks up everything and the $

 

To have an example below, I only have 4,000 sessions to authenticate and the impression it gives is that we have a lot more sessions than this are attempts ...

 

Today each has 300 sessions and 5% cpu. If you release a Vlan with more than 500 pppoe users, the cpu goes up and does not authenticate everyone and gets the CPU staying at 99%.

 

What can it be?

 

 

 

 

PTA : Locally terminated sessions
FWDED: Forwarded sessions
TRANS: All other sessions (in transient state)

TOTAL PTA FWDED TRANS
TOTAL 11708 316 0 11392
TenGigabitEthernet0/3/0.1001 11486 99 0 11387
TenGigabitEthernet0/3/0.1003 5 5 0 0
TenGigabitEthernet0/3/0.1004 100 100 0 0
TenGigabitEthernet0/3/0.1006 103 98 0 5
TenGigabitEthernet0/3/0.1010 14 14 0 0

 

CPU utilization for five seconds: 83%/5%; one minute: 78%; five minutes: 69%
PID Runtime(ms) Invoked uSecs 5Sec 1Min 5Min TTY Process
471 7840387 573779 13664 28.45% 25.34% 22.12% 0 VTEMPLATE Backgr
190 3613911 1732896 2085 17.39% 18.75% 14.72% 0 SSM connection m
191 1670678 1397436 1195 12.90% 12.70% 11.04% 0 SSS Manager

 

 

#show version
Cisco IOS XE Software, Version 03.16.06.S - Extended Support Release
Cisco IOS Software, ASR1000 Software (PPC_LINUX_IOSD-ADVENTERPRISEK9-M), Version 15.5(3)S6, RELEASE SOFTWARE (fc3)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2017 by Cisco Systems, Inc.
Compiled Mon 24-Jul-17 20:42 by mcpre




ROM: IOS-XE ROMMON

BRAS uptime is 2 weeks, 2 days, 1 hour, 3 minutes
Uptime for this control processor is 2 weeks, 2 days, 1 hour, 8 minutes
System returned to ROM by reload at 16:47:33 EST Tue Aug 15 2017
System restarted at 16:53:07 EST Tue Aug 15 2017
System image file is "bootflash:asr1000rp1-adventerprisek9.03.16.06.S.155-3.S6-ext.bi"
Last reload reason: Reload Command

 

 

cisco ASR1002 (2RU) processor (revision 2RU) with 1639051K/6147K bytes of memory.
Processor board ID FOX1352GPXZ
4 Gigabit Ethernet interfaces
2 Ten Gigabit Ethernet interfaces
32768K bytes of non-volatile configuration memory.
4194304K bytes of physical memory.
7798783K bytes of eUSB flash at bootflash:.

Configuration register is 0x2102

 

 

1 Reply 1

Patrizi.Stefano
Level 1
Level 1
Hello,
I have the same problem with an ASR1002 (2RU), the CPU goes high and the process that works the most is "VTEMPLATE Backgr". Does anyone have any solution?