cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
2042
Views
0
Helpful
1
Replies

SCE 8000 recover mode

Hi. I have a SCE 8000 and each time I connect the optical bypass control cable to SCE to get traffic cross it. 2-5 min later the SCE go to recover mode.

I open a TAC request and send me a new SCM but the issue ocurred again.

1 REPLY 1

the issue was resolve. the problem is bug CSCuc76451.

apply the following workaround for this software defect:

Disable the HBC by executing the following CLI:

  • SCE8000#>configure
  • SCE8000(config)#>interface LineCard 0
  • SCE8000(config if)#>tunable GT_PL_MODULE__HBC_ENABLED value false

Please make sure that this CLI is executed after applying PQB.

Content for Community-Ad