Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
2286
Views
0
Helpful
1
Replies

SCE 8000 recover mode

Geovanny Xavier Ramirez Espinoza
Level 1
Level 1

‎12-01-2012 01:20 AM - edited ‎03-01-2019 02:38 PM

Hi. I have a SCE 8000 and each time I connect the optical bypass control cable to SCE to get traffic cross it. 2-5 min later the SCE go to recover mode.

I open a TAC request and send me a new SCM but the issue ocurred again.

Labels:
0 Helpful
1 Reply 1

Geovanny Xavier Ramirez Espinoza
Level 1
Level 1

‎12-18-2012 05:38 AM

the issue was resolve. the problem is bug CSCuc76451.

apply the following workaround for this software defect:

Disable the HBC by executing the following CLI:

  • SCE8000#>configure
  • SCE8000(config)#>interface LineCard 0
  • SCE8000(config if)#>tunable GT_PL_MODULE__HBC_ENABLED value false

Please make sure that this CLI is executed after applying PQB.

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents