CIVS-MSP-4RU

[shajeebkader]

Hi,

I recently replace a faulty hard disk in a CIVS-MSP-4RU server and the new hard disk still is rebuilding.

The hard disk capacity is 750 GB.

Please advice how to check the status of the raid configurayion on the new hard disk from cmd prompt.

[shajeebkader]

I recently replaced a faulty hard disk in a CIVS-MSP-4RU server and the new hard disk is still rebuilding.

The hard disk capacity is 750 GB.

Please advice how to check the status of the raid configuration on the new hard disk from cmd prompt

[Dirk Christeaens]

As root, you can try these:

/opt/MegaRAID/MegaCli/MegaCli -pdrbld -progdsply -physdrv\[E:S\] -aAll

or

/opt/MegaRAID/MegaCli/MegaCli -pdrbld -showprog -physdrv\[E:S\] -aAll

In above commands replace "E" and "S" by the Enclosure Device ID and Slot Number of the physical drive.

You can get this information for each drive via following command:

/opt/MegaRAID/MegaCli/MegaCli -pdlist -aall

[christmarcel]

why would you check the raid configuration from the command prompt?

if you are able to reach the server, you can check the raid status from https:///vsmc -> raid status

[shajeebkader]

Actullay ,I would like to check how much percentage of data has been replicated to the new hard disk inserted.

what should we do for this.