Default username/password won't work CIVS-IPC-3520
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-25-2017 05:33 AM
Hi,
I have two CIVS-IPC-3520 camera's and I'm trying to access them through a browser to set them up. The default username / password (admin/admin) isn't working. I also tried to bring them to their factory default settings by holding down the reset button for 15 seconds but that isn't working either.
Version of the camera's is: 1.2.1-73
Anybody any suggestions ?
Kind regards,
Roy
- Labels:
-
Physical Security
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-27-2017 05:11 AM
Yeah... I think I recall encountering something similar previously.
Have you tried admin /
What about admin and a blank password?
Let me know!
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-27-2017 06:21 AM
Hi Scott,
No this isn't working either... but the default username/password is admin/admin.
I found out what the problem was. It's Safari ! If I try to connect via Safari it comes back asking for the username and password over and over again. When I use Chrome it logs in correctly.
Roy
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-28-2017 05:19 AM
Ahhh... yup. You'll find that Internet Explorer will probably provide the most consistent
Oh, and try not to run any browser extensions or plugins
