01-14-2011 02:27 PM
My goal is to setup an IP camera that can be broken into two different feeds. One being a direct feed and the other a child feed. I have setup the IP camera and gotten it to connect but the "stream_type" listed in camera feeds is called "dual 1". I would like to get the stream_type for this camera to be direct. How can I achieve that?
01-17-2011 12:52 PM
It basically goes like this:
(IP Cam) >---- direct proxy ----> (VSMS) >------ child proxy -----> (Alternate or Remote VSMS)
... is this what you are implying by a child proxy? What are you trying to do with it?
01-24-2011 07:31 AM
What I am trying to get done with the camera is have 2 feeds come out of it. The other cameras on the system are creating one feed with a chld stream type and another feed with a direct stream type. The camera that I added in has a "dual1" stream type. I am trying to get it to match the othr cameras. Does the proxy require server configuration?
Thank you for your help!
02-04-2011 03:57 PM
um, dual 1 refers to a cam with "dual" streams/feeds
and the "1" means you're using the 1st stream/feed
of the two dual streams, is this any help?
02-04-2011 04:49 PM
The Dual 1 points to one of two available feeds and the primary Feed.
The Dual 2 or secondary feed will listed as such.
This is for Cisco Cameras.
A Direct Feed designation may be from a camera that has only one stream to give from the camera itself.
As someone pointed out, there is a way to get a server to provide you a child feed off of the main camera feed.
The server acts as the encoder per se.
You can get different FPS from the child feed if the main feed is a MJPEG, other wise it will have the same specs as the main feed.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide