Buy or Renew
Buy or Renew
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
1404
Views
0
Helpful
1
Replies

ACS - Allow user to login and go straight to enable mode

cmelbourne
Level 1
Level 1

‎01-09-2004 08:10 AM - edited ‎03-10-2019 07:37 AM

I am running ACS version 3 and have several routers around the network.

I currently have it setup so tacacs is enabled and when you telnet or console into one of the routers it asks for a username and password, If the user who logins is authorised for enabled mode he can then type in enable but is it possible so when the user logs in and he is authorised for privalage commands can he go straight to enable mode without typing in enable.

Any ideas

Labels:
0 Helpful
1 Reply 1

d.parks
Level 1
Level 1

‎01-09-2004 09:11 AM

Yes this can be done.

You'll need to enable "aaa authorization exec" on the router(s), and set the privilige level in ACS to 15 in the "shell" section.

0 Helpful
Customers Also Viewed These Support Documents