Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,if i have a vlan (say vlan 2) that has the following setup.interface vlan 2ip address 10.1.1.254 255.255.255.0ip address 10.2.1.254 255.255.255.0 secondaryip address 10.3.1.254 255.255.255.0 secondaryip proxy-arp!now, i have a number of devices in...
Hi,we have a customer with cisco express and unity express using an AIM-CUE module.we are planning on upgrading the software from version 2.3 to 3.1 i think it is. (one of the latest ones).am i right in thinking we could get a spare aim-cue with the ...
Is it possible to have the VMWare and ESX Servers connected to two seperate 3750 switches (NOT IN A STACK) that in turn connects back to a core switch and run HA on the ESX VMWARE Servers?I know you can do by running etherchannel from two cisco switc...
Hi,our user is experiencing that when they make a call and the call is established they sometimes hear a ringing tone in the background on the call. it is not when they only dial a certain numebr but seems to be randmon, it also occurs on about 5 or ...
is there a way to have firewall load balencers (sidewinder not cisco) connected to two seperate cisco switches but on the same vlan without having to add the static arp or static mac-address in the cisco switches but still be seen from this vlan but ...
hey,thanks for the update.only done it once before and was a bit of a pain to be honest. i am going from release 2.1 to a fairly new release and said you need to do a clean install it says. does a clean install mean you lose the config and voicemails...
not sure to be honest with you as someone else deals with the VMWare bit.The guy reckons the VMWare servers are not sending the same MAC address but send the same IP address and need to load balence
