cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
625
Views
0
Helpful
3
Replies
Highlighted
Beginner

ISE NTP Time Source

20190613_152122.png

 

I configured NTP point to my Window server for time synchronization.

Unfortunately ISE always select LOCAL(*127.127.1.0) as a time source.

Does we have any configuration to force the ISE to sync time with Window Server?

Thank for your kindly support.

Note that ISE is VM-based.

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: ISE NTP Time Source

There is no way to force ISE to sync with NTP other then the command itself that should trigger a sync.

It just may be your looking at an issue with your Windows NTP setup.
You could quickly setup NTP on your switch and then point ISE to it , just to rule out issues.

3 REPLIES 3
Collaborator

Re: ISE NTP Time Source

HI,

Have you looked at the following doc:

https://www.cisco.com/c/en/us/support/docs/security/identity-services-engine/119371-technote-ise-00.html

 

Thanks

John

**Please rate posts you find helpful**
Cisco Employee

Re: ISE NTP Time Source

There is no way to force ISE to sync with NTP other then the command itself that should trigger a sync.

It just may be your looking at an issue with your Windows NTP setup.
You could quickly setup NTP on your switch and then point ISE to it , just to rule out issues.

VIP Advisor

Re: ISE NTP Time Source

Try to restart ntp service or delete the ntp server and readd as it takes
time to resync.