09-03-2008 11:59 AM - edited 03-15-2019 01:01 PM
Hi,
I have a VG224 integrated to CCM with SCCP. I noticed that a voice-port is not registered, but all the others are registered.
I tried reseting the analog phone from CCM, shut/no shut under dial-peer pots, erasing the dial-peer at all, but registration is unsuccessful. I did a debug sccp events, debug sccp messages to see if there is an output when performing a shut/no shut of the dial-peer but I don't see any output.
Can I assume that the voice-port is completely damaged?
Regards,
- Adrián.