Hi All,
I have a problem when attempting to access the console port of my Cisco 3560E switches. When I attach a console cable and using my terminal client (PuTTY), I get no response from the console. If I use the same settings, cable, etc on my 2960G switches I get to the console.
Here is the sh ver from the switch
License Level: ipservices
License Type: Permanent
Next reload license Level: ipservices
cisco WS-C3560E-48TD (PowerPC405) processor (revision D0) with 0K/8184K bytes of memory.
Processor board ID FDO1225V002
Last reset from power-on
7 Virtual Ethernet interfaces
1 FastEthernet interface
52 Gigabit Ethernet interfaces
2 Ten Gigabit Ethernet interfaces
The password-recovery mechanism is enabled.
512K bytes of flash-simulated non-volatile configuration memory.
Base ethernet MAC Address : 00:22:55:0F:51:80
Motherboard assembly number : 73-10319-12
Motherboard serial number : FDO122408WX
Model revision number : D0
Motherboard revision number : A0
Model number : WS-C3560E-48TD-E
Daughterboard assembly number : 800-28590-01
Daughterboard serial number : FDO12230FJE
System serial number : FDO1225V002
Top Assembly Part Number : 800-27548-02
Top Assembly Revision Number : C0
Version ID : V01
CLEI Code Number : COM7G10ARA
Hardware Board Revision Number : 0x01
Switch Ports Model SW Version SW Image
------ ----- ----- ---------- ----------
* 1 54 WS-C3560E-48TD 12.2(44)SE2 C3560E-UNIVERSALK9-M
Configuration register is 0xF
And also the configuration of the line console 0
line con 0
exec-timeout 5 0
password 7 ***********
logging synchronous
login authentication CONSOLE (defined for local line password in aaa)
transport preferred none
transport output none
Any ideas?
Thanks
Darren
