Hi there,
I'm facing a bit challenging problem. When I boot one accesspoint it gives only next listing in the screen:
Xmodem file system is available.
Flashfs[0]: unable to allocate available block.
The system has been interrupted, or encountered an error during initializion of the flash filesystem.
The foolowing commands will initialize the flash filesystem, and finish loading the operating system software:
flash_init
ether_init
tftp_init
boot
When I type this commands, it doesn't help at all. The output will be following:
ap: flash_init
Initializing Flash...
flashfs[0]: out of memory
...done Initializing Flash.
ap: ether_init
Initializing ethernet port 0...
Reset ethernet port 0...
Reset done!
ap: tftp_init
Unable to get our ip address: no "IP_ADDR" variable set
ap: boot
Loading ""...; permission denied
Error loading ""
Interrupt within 5 seconds to abort boot process.
Boot process failed...
ap:
I've tried to set ip address, but flash is out of memory and even tried other measures like: Restore IOS on Cisco AP1200https://supportforums.cisco.com/thread/326515?referring_site=kapi but none seemed to work. It just doesn't take the IOS in it.
What to do?
KR, Miika
