10-17-2010 03:15 AM
Hi all,
I have a problem to get lldp to work.
My setup is as follows:
Router (with lldp support) <----> Linksys SRW2008 <----> Workstation (with lldp support)
Querying lldp neighbors from my router show up only its own interfaces:
vyatta@vyt-node01:~$ show lldp neighbors
Capability Codes: R - Router, B - Bridge, W - Wlan r - Repeater, S - Station
D - Docsis, T - Telephone, O - Other
Device ID Local Proto Cap Platform Port ID
--------- ----- ----- --- -------- -------
vyt-node01 eth2 LLDP R Vyatta Router eth0
vyt-node01 eth0 LLDP R Vyatta Router eth2
vyatta@vyt-node01:~$
Querying lldp from SRW2008 do no show up anything:
cal-swge01-linksys# show lldp neighbors
Port Device ID Port ID System Name Capabilities
------- ----------------- ----------------- ------------------- ------------
From the workstation nothing shows up.
I replaced the SRW2008 with a Surecom unmaned switch as follows:
Router (with lldp support) <----> Surecom switch <----> Workstation (with lldp support)
and from the router I see lldp informations from my workstation.
The question is, why the srw2008 block lldp traffic ? what do I hav to change on order to get lldp to work ?
Thnaks in advance
Roberto