Community,
I just purchased a SG200-50P switch to replace a WS-CE500-24LC, that had a limited amount (4) of PoE ports. I was running Cisco 7940 IP Phone, Cisco AP1231 and AP1100 series access points via PoE off of this switch.
When I attempt to plug in these device types into the SG200-50P they do not power up. What is going on? Why do these devices (7940 IP Phone, 7960 IP Phone, AP1100 series access point, AP1231 series access point) not get PoE from the SG200-50P switch?
Is there a setting to enable these devices to receive PoE from the switch?
Thanks for your help.
