Hello all,
I have an 881 router here in house and am attempting to enable the gui interface on the router.
I have tried the steps to enable http but have not had any success.
Below is the IOS Version and the portion of the show config that reflects the http allow:
ROM: System Bootstrap, Version 12.4(15r)XZ2, RELEASE SOFTWARE (fc1)
Cisco 881 (MPC8300) processor (revision 0x100) with 249856K/12288K bytes of memory.
Processor board ID FTX1249Y16Q
!
!
!
ip forward-protocol nd
ip route 0.0.0.0 0.0.0.0 FastEthernet4 x.x.x.x removed
ip http server
ip http access-class 23
ip http authentication local
ip http secure-server
ip http timeout-policy idle 60 life 86400 requests 10000
any help would be appreciated at this point.
Thanks,
Bruce
