I have a WAP4410N which I have had for awhile and the performance was flawless at what appeaared to be 300 Mbps. I udated the firmware recently to 2.0.4.2. This is when the problems started. Within 15 feet of the acccess point it would drop the connection and speeds were under 65 Mbps. I factory defaulted the unit and reinstalled the firmware with no changes. I run several other access points of differnt manufacturers and I get fantastic performance on draft N and G. I did check all the laptops for network adapter incosistansies. Have I made a configuation mistake? I only changed the IP address to bring it into the range of other devices. I use a sa520 router and a Trendnet Gigabit switch and a server with MS SBS 2008 which works well with all but the WAP4410N. Any assistance is appreciated. Thanks, Brad
