Hi All
We have a Cisco Catalyst 4506 running:
"Cisco IOS Software, Catalyst 4000 L3 Switch Software (cat4000-I9K91S-M), Version 12.2(25)EWA14, RELEASE SOFTWARE (fc1)"
I have configured the default gateway as:
ip default-gateway X.Y.116.65
However, when I do, "show ip route", it only shows the 3 connected networks and states "Gateway of last resort is not set".
The Command "ip classless" is not set. I read on some blogs that this might explain the issue. However, when I go into config mode (config t), I get the following output:
Switch(config)#ip classless
^
% Invalid input detected at '^' marker.
Switch(config)#
I can't ping the switch from outside the connected networks and cannot connect via vty onto the switch from outside the connected networks.
Can anybody help?
Many Thanks
John
