Hi, i'm ryan. i wanna ask about my problem here.
There is a topology like this:
Phone_A (extension: 3304) - PBX - Router - Phone_B (FXS - extension 8989).
To connect Router to PBX using E1.
the PBX is a Panasonic TDA600 and connection to the router using PRI Module 30ch,
the Router is C2811 Router include VWIC2-2MFT-T1/E1 for connection to the PBX.
Router and PBX located in one building.
I have configure the router (capture attached). And was able to make calls from Phone_A to Phone_B (direct extension).
the PBX also have been configured, for a number that begins with 89 will be passed to the trunk-group PRI30ch
. From PBX to test the connection to the router, it is checked by calling* 851 from Phone_A, if the connection is correct, then Phone_A will receive a long tone,and now it was successful & no problem.
Now the problem is, Phone_A can not directly dial the extension of Phone_B (appears busy tone). but Phone_A can call Phone_B by call * 851 first, if it receive long tone, and we press extension 8989 so the calls can be really successfully.
I need solution? how to Phone_A can directly call Phone_B, direct call the extention i mean,not using the * 851 first.
Hopefully anyone can help me.
Thank's before for the help.
Regards,
Ryan
