Dear Experts,
We are using Cisco 3750-12-S Swtich in this switch only one Giga inteface 1/0/6 increase Input & CRC Error when data transmit.
We are facing the issue Input & CRC Error increasing when data transmit from interface gi1/0/6 Onl and other ports are working fine.
We alrady change SFP Module and also New Cable ( same cable and SFP Module when use other port it's working fine but in this perticulary port generate Input and CRC error when data transmit. WHEN NO ANY DATA TRANMIT ON THIS PORT THAT TIME NO ANY ERRORS)
GigabitEthernet1/0/6 is up, line protocol is up (connected)
Hardware is Gigabit Ethernet, address is 0012.00cf.fb86 (bia 0012.00cf.fb86)
Description: *** Connect to ATX ***
MTU 9000 bytes, BW 100000 Kbit, DLY 100 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation ARPA, loopback not set
Keepalive not set
Full-duplex, 100Mb/s, link type is auto, media type is 10/100/1000BaseTX SFP
Media-type configured as connector
input flow-control is off, output flow-control is unsupported
ARP type: ARPA, ARP Timeout 04:00:00
Last input 01:51:07, output 00:49:09, output hang never
Last clearing of "show interface" counters 00:15:07
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: fifo
Output queue: 0/40 (size/max)
5 minute input rate 9000 bits/sec, 5 packets/sec
5 minute output rate 407000 bits/sec, 29 packets/sec
177722 packets input, 52353871 bytes, 0 no buffer
Received 219 broadcasts (0 multicast)
0 runts, 0 giants, 0 throttles
482 input errors, 276 CRC, 0 frame, 0 overrun, 0 ignored
0 watchdog, 149 multicast, 0 pause input
0 input packets with dribble condition detected
275929 packets output, 300453718 bytes, 0 underruns
0 output errors, 0 collisions, 1 interface resets
0 babbles, 0 late collision, 0 deferred
0 lost carrier, 0 no carrier, 0 PAUSE output
0 output buffer failures, 0 output buffers swapped out
So what is the issue and how to resolve it.
Thanks in ADV,
