07-17-2012 10:25 PM - edited 03-04-2019 05:00 PM
i'm new to cisco router, recently i accidently remove the CF memory card from running cisco router, which result cisco goes to rommon mode with and can't start-up. here is the details error ,
System Bootstrap, Version 12.4(13r)T, RELEASE SOFTWARE (fc1)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 2006 by cisco Systems, Inc.
PLD version 0x10
GIO ASIC version 0x127
c2801 platform with 131072 Kbytes of main memory
Main memory is configured to 64 bit mode with parity disabled
Readonly ROMMON initialized
program load complete, entry point: 0x8000f000, size: 0xcb80
program load complete, entry point: 0x8000f000, size: 0x161482c
Self decompressing the image : #################################################
###################################################################### [OK]
Wrong system software for this hardware
System Bootstrap, Version 12.4(13r)T, RELEASE SOFTWARE (fc1)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 2006 by cisco Systems, Inc.
PLD version 0x10
GIO ASIC version 0x127
c2801 platform with 131072 Kbytes of main memory
Main memory is configured to 64 bit mode with parity disabled
Readonly ROMMON initialized
program load complete, entry point: 0x8000f000, size: 0xcb80
program load complete, entry point: 0x8000f000, size: 0xcb80
program load complete, entry point: 0x8000f000, size: 0x161482c
Self decompressing the image : #################################################
###################################################################### [OK]
Wrong system software for this hardware
System Bootstrap, Version 12.4(13r)T, RELEASE SOFTWARE (fc1)
Technical Support: http://www.cisco.com/tec
Copyright (c) 2006 by cisco Systems, Inc.
PLD version 0x10
GIO ASIC version 0x127
c2801 platform with 131072 Kbytes of main memory
Main memory is configured to 64 bit mode with parity disabled
Readonly ROMMON initialized
program load complete, entry point: 0x8000f000, size: 0xcb80
program load complete, entry point: 0x8000f000, size: 0xcb80
program load complete, entry point: 0x8000f000, size: 0x161482c
Self decompressing the image : #################################################
###################################################################### [OK]
Wrong system software for this hardware
Readonly ROMMON initialized
rommon 1 >
How can I make my router work normally again ? is there something i should do to reset my router to factory default from Rommon mode ?
i don't care if i lost my running-config (i have backup it previously) i used Cisco 2800 Series..
thanks for your respons..
Solved! Go to Solution.