This may be nothing, but I've not seen it before. While investigating another problem I've noticed the CLI output for "sh int status" on one of our Catalyst 6509Es is returning interfaces out-of-order. Should I be concerned?
Port Name Status Vlan Duplex Speed Type
Te1/4 connected trunk full 10G 10Gbase-SR
Gi3/7 connected 663 full 1000 1000BaseSX
Po6 connected 663 a-full a-1000
Te1/1 notconnect 1 full 10G 10Gbase-LR
Te1/2 connected 11 full 10G 10Gbase-ER
Te1/3 disabled routed full auto No Connector
Te2/1 connected trunk full 10G 10Gbase-LR
Te2/2 disabled 11 full 10G No Connector
Te2/3 disabled routed full auto No Connector
Te2/4 disabled routed full auto No Connector
Gi3/1 disabled 1 full 1000 1000BaseSX
Gi3/2 connected 663 full 1000 1000BaseSX
Gi3/3 connected trunk full 1000 1000BaseZX
Gi3/4 connected 82 full 1000 1000BaseSX
Gi3/5 disabled 1 full 1000 1000BaseSX
Gi3/6 notconnect routed full 1000 1000BaseSX
Gi3/8 disabled routed full 1000 No Transceiver
etc...
Thanks in advance
Message was edited by: Alan Boyd
