01-08-2013 10:13 AM - edited 03-04-2019 06:38 PM
Hi Everyone,
4500 device has config for GRE only.
I cleared the counters but drops are incrementing rapidly
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation TUNNEL, loopback not set
Keepalive not set
Tunnel source 192.168.130.254 (Loopback3), destination 192.168.128.254
Tunnel protocol/transport GRE/IP
Key disabled, sequencing disabled
Checksumming of packets disabled
Tunnel TTL 255, Fast tunneling enabled
Tunnel transport MTU 1476 bytes
Last input never, output never, output hang never
Last clearing of "show interface" counters 02:44:05
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 2125
Queueing strategy: fifo
Output queue: 0/0 (size/max)
5 minute input rate 0 bits/sec, 0 packets/sec*******
5 minute output rate 0 bits/sec, 0 packets/sec************
0 packets input, 0 bytes, 0 no buffer
Received 0 broadcasts (0 IP multicasts)
0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
2125 packets output, 127500 bytes, 0 underruns
0 output errors, 0 collisions, 0 interface resets
0 output buffer failures, 0 output buffers swapped out
Here it does not show much data going via tunnel
Tunnel config is
interface Tunnel1
ip address 192.168.124.2 255.255.255.252
delay 7
tunnel source Loopback3
tunnel destination 192.168.128.254
Need to know why total drops are incrementing and how can i check if data is passing via tunnel as currenlty transmit and receive load is empty.
thanks
mahesh
Solved! Go to Solution.