Hi,
I have a SG200-50P. It had a problem with the PoE ports (didn't supply power to my Bosch POE security cameras) so I updated it to the latest firmware. Now it does recognize the cemeras and supplies power to them. However, there are a few problems:
1. The boot time is extremely long, maybe 15-20 minutes for it to become ready. I've tried to reset to factory default settings, push the reset button for 30+ seconds, and disconnect all the ports. The boot time was always very long.
2. Even thought it supplies power to the cameras, the PoE lights on the ports are not lit.
3. The log is filled with this error, posted every second.
| 2147434520 | 2013-Apr-12 11:40:23 | Alert | %HAL_config_poe-A-POEFailDetected: POE ERROR(i2c_read_mem failed addr 0x12e6 dev_num 0 val 0x0) was detected: POE is Disabled untill Reset |
| 2147434521 | 2013-Apr-12 11:40:22 | Alert | %HAL_config_poe-A-POEFailDetected: POE ERROR(i2c_read_mem failed addr 0x139c dev_num 0 val 0x0) was detected: POE is Disabled untill Reset |
|
Occasionally it has his error
| 2147434525 | 2013-Apr-12 11:40:19 | Alert | %HAL_config_poe-A-POEFailDetected: POE ERROR(HALP_config_poe_690xx_check_master_reset - Master HW RESET . val 0x0 dev_num 0!!) was detected: POE is Disabled unt ill Reset |
And these errors are generated even if I disconnect all the PoE ports.
