cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Who Me Too'd this topic

consistency check is successful but vpc peer link is down ? why ?

kthned
Level 3
Level 3

Hi

I am unable to make the vPC peer link up between N7K. The consistency seems fine between the two N7K.

When I shut and no shut the vpc peer link, the vpc links come alive for very short period (==3 sec) and then go down again with following log in red.

%VPC-3-VPC_PEER_LINK_BRINGUP_FAILED: vPC peer-link bringup failed (vPC peer is not reachable over cfs)

%ETHPORT-3-IF_ERROR_VLANS_SUSPENDED: VLANs 2100-2101,2104-2149,2200-2249 on Interface port-channel10 are being suspended. (Reason: vPC peer is not reachable over cfs)

Sh vpc below

gw01-vdc01(config)# sh vpc

Legend:

                (*) - local vPC is down, forwarding via vPC peer-link

vPC domain id                     : 10

vPC+ switch id                    : 112

Peer status                       : peer link is down

vPC keep-alive status             : peer is alive

vPC fabricpath status             : peer is reachable through fabricpath

Configuration consistency status  : success

Per-vlan consistency status       : success

Type-2 consistency status         : success

vPC role                          : primary

Number of vPCs configured         : 0

Peer Gateway                      : Disabled

Dual-active excluded VLANs        : -

Graceful Consistency Check        : Enabled

Auto-recovery status              : Disabled

Fabricpath load balancing         : Disabled

Port Channel Limit                : limit to 244

vPC Peer-link status

---------------------------------------------------------------------

id   Port   Status Active vlans

--   ----   ------ --------------------------------------------------

1    Po10   down   -

gw01-vdc01(config-if)# sh running-config vpc all

!Command: show running-config vpc all

!Time: Thu Jun 13 14:59:56 2013

version 6.1(3)

feature vpc

logging level vpc 5

vpc domain 10

  role priority 32667

  system-priority 32667

  peer-keepalive destination 172.18.10.5 source 172.18.11.5 udp-port 3200 vrf management interval 1000 timeout 5 precedence 6  hold-timeout 3

  delay restore 30

  no dual-active exclude interface-vlan

  no peer-gateway

  no Layer3 peer

  graceful consistency-check

  no auto-recovery

  delay restore interface-vlan 10

  fabricpath switch-id 112

  no fabricpath multicast load-balance

  port-channel limit

interface port-channel10

  vpc peer-link

Can some expert help me in this.

Thanks

//Umair

Who Me Too'd this topic