Ok so I have the following model:
CISCO891W-AGN-A-K9
Software version: 15.3(3)M
I just installed the PoE daugter card (800-IL-PM-4), which according to the 890 Q&A is field-upgradeable.
I've followed the basic instructions, installing the module in the router and connecting the additional power-supply.
The module is show in "show inventory"
#sh inv
NAME: "891", DESCR: "891 chassis, Hw Serial#: X, Hw Revision: 1.0"
PID: CISCO891W-AGN-A-K9, VID: V03, SN: X
NAME: "ESW Power Daughter Card", DESCR: "4-Port ESW Power Daughter Card"
PID: 800-IL-PM-4 , VID: V04, SN: X
Here's where I'm stuck at.
I have no option in the IOS to do any of the PoE-related show or configuration commands.
exec-mode "show power inline" doesn't exist.
interface-mode "power inline {...}" doesn't exist.
#show po?
policy-firewall policy-manager policy-map
And (obviosuly) the poe doesn't work...
I've gone through the Cisco guides I've on this subject, an all they mention is the hardware installation (how to screw it in) and then using these commands.
I'm pretty sure I've missed out some fundamental or basic thing here...
Any thoughts?
