10-14-2013 06:32 AM - edited 03-11-2019 07:52 PM
Hi I'm running a 5505 version 8.4(2).
Around a month ago i addedd a second interface called inside2. Everthing was going fine until I needed to expose some websites on the new network to external parties. If i try to access the sites via my outside interface I see "no valid adjacency" in the log files. If I run a packet trace from the outside interface to the inside2 interface is see the following...
|
|
|
|
|
Here is the relevant portion of my config...
Result of the command: "sh run"
: Saved
:
ASA Version 8.4(2)
!
interface Ethernet0/0
switchport access vlan 2
!
interface Ethernet0/1
!
interface Ethernet0/2
!
interface Ethernet0/3
!
interface Ethernet0/4
switchport access vlan 15
!
interface Ethernet0/5
switchport access vlan 5
!
interface Ethernet0/6
!
interface Ethernet0/7
!
interface Vlan1
nameif inside
security-level 100
ip address 192.168.57.1 255.255.255.0
!
interface Vlan2
nameif outside
security-level 0
ip address 77.221.164.138 255.255.255.0
!
interface Vlan15
nameif inside2
security-level 75
ip address 192.168.59.1 255.255.255.0
!
object network obj_any
subnet 0.0.0.0 0.0.0.0
object network obj_any_inside2
subnet 0.0.0.0 0.0.0.0
object network webserver16
host 192.168.59.22
object network webserver14
host 192.168.59.19
access-list outside_access extended permit object-group HTTP(S) any object webserver16
access-list outside_access extended permit object-group HTTP(S) any object webserver14
!
object network obj_any
nat (inside,outside) dynamic interface
object network obj_any_inside2
nat (spinsport,outside) dynamic interface
object network webserver16
nat (inside,outside) static 77.221.164.141
object network webserver14
nat (inside,outside) static 77.221.164.142
access-group outside_access in interface outside
access-group global_access global
route outside 0.0.0.0 0.0.0.0 77.221.164.137 1
What exactly am i doing wrong here?
Solved! Go to Solution.