11-15-2013 05:56 AM - edited 07-04-2021 01:16 AM
Hi There,
I installed two wism2 modules in our cat6509.
After basic configuration the modules comes up and I can connect via ssh/https to the controller.
For first configuration of the wism modules, I opened a session directly from the cat6509.
Now after 24 hours, there is no way to make a connection via session command from cat6509.
--------------------------------------------------
cat6509#session slot 9 processor 1
The default escape character is Ctrl-^, then x.
You can also type 'exit' at the remote prompt to end the session
Trying 192.168.12.100 ...
% Connection refused by remote host
---------------------------------------------------
cat6509#session slot 2 processor 1
The default escape character is Ctrl-^, then x.
You can also type 'exit' at the remote prompt to end the session
Trying 192.168.12.101 ...
% Connection timed out; remote host not responding
Has anybody an idea why I can not open a session to wism2 module?
Thanks
Bjoern