Hi All,
I am configuring MAB authentication for IBMS devices(some buliding infra devices) but MAB was not getting triggered.
I tried using the following solution as well,
https://supportforums.cisco.com/thread/2015988
it says I should changed control-direction to inbound "dot1x control-direction in", that let the MAB work. By applying this interface level command I can see that session is getting authorized but still I can not ping the devices.
Can someone exactly confirm whats the issue over here and how to resolve?
My config on port is as follows,
!
int ten1/1/9
switchport mode access
authentication host-mode single-host
authentication port-control auto
authentication violation restrict
authentication control-direction in
mab
!
Regards,
