we have a cisco asa5510 and I have firewall rules setup to allow all traffic incoming and outgoing from the pitney bowes device, I have forwarded ports required all except 443 as it is used by the SDM to access the firewall for management. Stil this unit wont connect right and download its software, Pitney Bowes gave a long document about forwarding and allowing every port on the device forwarded to this thing, but it just doesnt seem reasonable to open up all of these ports to one device. Anyone have any experience setting up an ASA5510 to work with a Pitney Bowes network based device behind it. This is very frustrating.
