Helllo,
I'm configuring my ASR 1000 router with an Ethernet over GRE tunnel. Anytime I sent the Ethernet over GRE messages to the tunnel, the ASR router didn't recognize the messages were sent over the GRE tunnel. The ASR said that the messages were received on the LAN management interface, which was not what I intended. I'm wondering if the messages were not encapsulated correctly or I need to configure more on the ASR. I attached an ARP over GRE message capture.
Here is the router's log
*Jun 4 13:48:00.371: IP ARP: rcvd req src 10.14.18.1 0025.642c.4441, dst 10.14.18.152 GigabitEthernet0
*Jun 4 13:48:01.404: IP ARP: rcvd req src 10.14.18.1 0025.642c.4441, dst 10.14.18.152 GigabitEthernet0
*Jun 4 13:48:02.503: IP ARP: rcvd req src 10.14.18.1 0025.642c.4441, dst 10.14.18.152 GigabitEthernet0
Here is my ASR configuration
version 15.3
service timestamps debug datetime msec
service timestamps log datetime msec
no platform punt-keepalive disable-kernel-core
!
hostname moonstone
!
boot-start-marker
boot system flash bootflash:asr1000rp2-adventerprise.03.09.01.S.153-2.S1.bin
boot-end-marker
!
!
vrf definition Mgmt-intf
!
address-family ipv4
exit-address-family
!
address-family ipv6
exit-address-family
!
!
no aaa new-model
!
!
!
ip dhcp pool dhcp_over_gre_1
network 172.16.0.0 255.255.0.0
!
ip dhcp pool dhcp_over_gre_2
network 212.1.0.0 255.255.0.0
!
ip dhcp pool dhcp_over_gre_3
network 200.1.0.0 255.255.0.0
!
multilink bundle-name authenticated
!
!
spanning-tree extend system-id
!
redundancy
mode sso
!
!
!
ip ftp source-interface GigabitEthernet0
ip tftp source-interface GigabitEthernet0
!
!
interface Loopback0
ip address 130.130.130.130 255.255.255.255
!
interface Tunnel0
mac-address 0000.5e00.0001
ip address 172.16.1.1 255.255.255.0
no ip redirects
tunnel source TenGigabitEthernet1/0/0
tunnel mode ethernet gre ipv4
!
interface GigabitEthernet0/0/0
no ip address
ip broadcast-address 0.0.0.0
negotiation auto
!
interface GigabitEthernet0/0/1
no ip address
ip broadcast-address 0.0.0.0
negotiation auto
!
interface GigabitEthernet0/0/2
no ip address
ip broadcast-address 0.0.0.0
negotiation auto
!
interface GigabitEthernet0/0/3
no ip address
ip broadcast-address 0.0.0.0
negotiation auto
!
interface GigabitEthernet0/0/4
no ip address
ip broadcast-address 0.0.0.0
negotiation auto
!
interface GigabitEthernet0/0/5
ip address 70.0.1.2 255.255.255.0
negotiation auto
!
interface GigabitEthernet0/0/6
no ip address
ip broadcast-address 0.0.0.0
negotiation auto
!
interface GigabitEthernet0/0/7
no ip address
ip broadcast-address 0.0.0.0
negotiation auto
!
interface GigabitEthernet0/0/8
no ip address
ip broadcast-address 0.0.0.0
negotiation auto
!
interface GigabitEthernet0/0/9
no ip address
ip broadcast-address 0.0.0.0
negotiation auto
!
interface TenGigabitEthernet1/0/0
ip address 200.1.1.1 255.255.255.0
!
interface TenGigabitEthernet1/0/0.2
encapsulation dot1Q 2
!
interface TenGigabitEthernet2/0/0
ip address 212.1.1.1 255.255.255.0
!
interface GigabitEthernet0
vrf forwarding Mgmt-intf
ip address 10.14.18.130 255.255.255.0
negotiation auto
no mop enabled
!
router ospf 9
network 70.0.1.0 0.0.0.255 area 0
!
ip forward-protocol nd
!
no ip http server
ip route vrf Mgmt-intf 10.14.0.0 255.255.0.0 10.14.18.1
ip route vrf Mgmt-intf 10.15.0.0 255.255.0.0 10.14.18.1
!
!
control-plane
!
!
line con 0
stopbits 1
line vty 0 4
exec-timeout 0 0
password spirent
login
!
!
end
