I just got one of these Access Points and I need to set it up. No guide online helped me so far, except one that says I need a controller of some sort on the same network. Is there a way to set up the Access Point easily without any additional hardware?
I have plugged ETHERNET to a router w/ DHCP and it now has an IP Address but no port is accessible. I have tried pressing the MODE button and then powering it until the LED becomes Amber but that does nothing.
As far as I understand the CONSOLE port uses some proprietary protocol that makes it need additional hardware to use.
Isn't there a simple way to visit this IP on port 80 and have a Web UI?
