03-10-2015 04:23 PM - edited 03-12-2019 05:38 AM
I have two ASA's running in active standby mode, each with an ASA SF module. I am getting errors on the SF module in the Standby because it is not receiving any traffic. I believe it is by design that the standby ASA SF module is not receiving any traffic, but it I don't want my device to be in alarm in firesight. It looks like I can go into the Policy on the device and tell it not to report on this value, but I do want to know if the prod unit that is using the same policy isn't receiving traffic. What is the recommended practice for handling this alarm?