Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a pair of c9300x-24y running in Meraki mode with the c9300x-NM-4C, when they were purchased it was indicated that support for this module was road mapped and we did not have an immediate need to use these uplink ports. A year later we are addi...
There is a detailed NSX-T on ACI design guide that details the use of the L3-Out via an SVI for peering with the NSX-T Tier0 Edge Node. I am looking for the equivalent reference design guide for peering with an NSX-T edge node from a Nexus VXLAN/EVPN...
In a CW9164 Proof of concept the 9164 APs are reserving 47.2 Watts of POE from the 9300L MGIG Switch that they are connected to. As per the data sheet with the USB turned off they should only be reserving 25 Watts. Is there an explanation for the lar...
I have two ASA's running in active standby mode, each with an ASA SF module. I am getting errors on the SF module in the Standby because it is not receiving any traffic. I believe it is by design that the standby ASA SF module is not receiving any tr...
I am looking for some information on the ability to write Zone Based access Control rules using the Sourcefire on ASA module. I can create ASA security Zones which it looks like basically just associate the interfaces on the ASA with a security Zone,...
Why wouldn't it be supported to order the Power supplies and Fans to reverse the airflow. The use case for this is moving the switch to a new location that requires reversed airflow. Why would cisco build it with replaceable color coded fans and powe...
Aninda,I have 6880 VSS pair running 15.1(2)SY3 and ran into the issue where FEX cannot receive upgraded image due to the SVI for VLAN 1013 being in UP/Down state. I was able to clear the interface VLAN 1013 and bring the SVI into an UP/UP state. The ...
Why not do an MQC shaping policy outbound from both tunnel endpoints to shape the traffic on the tunnel interface.Here is an examplehttp://www.cisco.com/en/US/tech/tk543/tk545/technologies_tech_note09186a008017405e.shtml
I've run into this bug and the work around for us was to reload the standby supervisor. I don't have the bug details but if I recall at the time it wasn't that hard to find it in the bug tracker.
