Hello All,
I have three RV320 routers connected via gateway to gateway VPNs as follows:
Router A > Router B < Router C
Such that routers A and C connect to router B. All works fine as far as the VPN connections go except that clients from router A cannot get to router C and vice versa. Clients on router B can talk to both remote boxes without issue.
I've tried adding manual routing table entries in A and C but cannot seem to get them to work. I also enabled RIPv2 and was hoping the boxes would all broadcast their routes to one another but that doesn't work either.
Anybody have any of the same issues or any suggestions?
