I have a WAP371 on my network set up as a wireless bridge, DHCP function is handled by my RV325, and the wired network works fine. I've had this setup for several months now and about 2 weeks ago after constant use, the WAP371 stopped responding, didn't accept any new connections (SSID was still broadcast). I had to power it off and back on to resolve the issue. It just happened again yesterday, same exact issue. It has the latest firmware (as of 2 months ago) and the issue just started happening. I'm using the recommended Cisco PoE injector and only have a few wireless clients that even use the access point. Trying to figure out what may be causing this. All clients have the issue, so it's not an isolated case of just one device having a problem.
Any ideas or suggestions would be most welcome!
Thanks!
Kyle
