I am installing a pair of MDS9710 as part of an upgrade. But fails to complete the redundancy test for the management connections.
When I disconnect management port on active sup-module the other one did not pickup. At the same time only the active ports detected on the Nexus side. While the passive ports does not report any physical connection. Not sure if this the expected behavior. But for the test we removed the active connection. But the standby did not pickup.
is there a command to check the link status from MDS for the management port on standby sup-module?
Like "show cdp interface mgmt. 0" works for me for the active connection. we have the VLAN enabled on the switch side for the both the ports and set to auto negotiation.
