Hello Community
I've some questions about the TPCv2 Plan Quality Index in below output
Leader Automatic Transmit Power Assignment
Transmit Power Assignment Mode................. AUTO
Transmit Power Update Interval................. 600 seconds
Transmit Power Threshold....................... -70 dBm
Transmit Power Neighbor Count.................. 3 APs
Min Transmit Power............................. 10 dBm
Max Transmit Power............................. 30 dBm
Update Contribution
Noise........................................ Enable
Interference................................. Enable
Load......................................... Disable
Device Aware................................. Disable
Transmit Power Assignment Leader............... HP-AMM-WLC01 (10.1.59.1) (::)
Last Run....................................... 479 seconds ago
Last Run Time.................................. 9 seconds
TPC Mode....................................... Version 2 Per-Channel YES
TPCv2 Target RSSI.............................. -67 dBm
TPCv2 VoWLAN Guide RSSI........................ -67.0 dBm
TPCv2 SOP...................................... -85.0 dBm
TPCv2 Default Client Ant Gain.................. 0.0 dBi
TPCv2 Path Loss Decay Factor................... 3.6
TPCv2 Search Intensity......................... 10 Iterations
TPCv2 Plan Quality Index....................... Overall 546.1 Coverage 623.2 CCI 0.6 Ratio 0.1
TPCv2 Target Plan.............................. To be reached in 1 TPC runs
Q1: For the Overall value 546.1, What does it mean? Which indication I should understand reading such value (good, bad … etc)? What is the range that WLC use to assign to the parameter? Is between 0 and 1000 for example? Which is better close to zero or the other way?
Q2: • Coverage 623.2, What does it mean? Which indication I should understand reading such value (decent coverage, not good … etc)? What is the range that WLC use to assign to the parameter? Is between 0 and 1000 for example? Which is better close to zero or the other way?
Q3: For the Ratio, What does it mean? Which indication I should understand reading such value? between 0.0 and 10.0 for example? Which is better close to zero or the other way?
I'm asking because, I collected the Run-Config before performing the Site-Survey and I want to compare them with the values after the site-survey, but couldn't find any documentation and recommended value ranges in this ..
Regards
