Hi Guys,
I'm trying to setup a new Cisco Catalyst 2690-x and succesfully connected with the console cable and logged out after that. But the thing is I can't put in commands on my switch anymore. When I reboot the switch with my console cable in it, I can see that the booting output is given but
it stops generating output after "%USB_CONSOLE-6-MEDIA_RJ45: Console media-type is RJ45." After that I am unable to type anything but it will give me up/down messages if i connect a cable on a port.... Below is a part of the output where it keeps stopping.
Press RETURN to get started!
*Mar 1 00:00:27.720: Read env variable - LICENSE_BOOT_LEVEL =
*Jan 2 00:00:00.150: %IOS_LICENSE_IMAGE_APPLICATION-6-LICENSE_LEVEL: Module name = c2960x_lanbase Next reboot level = lanbase and License = lanbase
Jul 18 08:17:36.114: in Switch 0. Cannot read pid from Flexstack module
Jul 18 08:17:36.212: %HPAA:hpaa_port_bitmap_init:254:n_ports = 28, sizeof (**hpaa_port_bitmap.bitlist_array) = 16
Jul 18 08:18:13.709: %STACKMGR-4-SWITCH_ADDED: Switch 1 has been ADDED to the stack
Jul 18 08:18:15.052: %LINEPROTO-5-UPDOWN: Line protocol on Interface Vlan1, changed state to down
Jul 18 08:18:15.052: %LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0, changed state to down
Jul 18 08:18:16.890: %SPANTREE-5-EXTENDED_SYSID: Extended SysId enabled for type vlan
Jul 18 08:18:39.529: %STACKMGR-5-SWITCH_READY: Switch 1 is READY
Jul 18 08:18:39.529: %STACKMGR-4-STACK_LINK_CHANGE: Stack Port 1 Switch 1 has changed to state DOWN
Jul 18 08:18:39.529: %STACKMGR-4-STACK_LINK_CHANGE: Stack Port 2 Switch 1 has changed to state DOWN
Jul 18 08:18:39.903: %STACKMGR-5-MASTER_READY: Master Switch 1 is READY
Jul 18 08:18:39.906: %SYS-5-RESTART: System restarted --
Cisco IOS Software, C2960X Software (C2960X-UNIVERSALK9-M), Version 15.2(2)E6, RELEASE SOFTWARE (fc1)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2016 by Cisco Systems, Inc.
Compiled Fri 16-Dec-16 21:27 by prod_rel_team
Jul 18 08:18:41.878: %LINK-3-UPDOWN: Interface FastEthernet0, changed state to down
Jul 18 08:18:42.877: %LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0, changed state to down
Jul 18 08:18:43.458: %USB_CONSOLE-6-MEDIA_RJ45: Console media-type is RJ45.
I have tried to reboot the switch and set it back to factory default via the Mode button but it hasn't worked unfortunately.
The cable is working correctly as it still gives output and works when I try to connect it to my ASA.
The baud settings are correct as well.
I didn't change anything at the first startup of the switch
Do you guys have any idea how to regain access?
Thanks in advance
