Hello.
We have an SX80 codec with triple display, SpeakerTrack60 and PresenterTrack60.
We have set up the room type to Briefing room.
SpeakerTrack dual P60 are mounted in the front center of the room with monitor 1 on the left and monitor 2 on the right.
PresenterTrack P60 is mounted opposite to the SpeakerTrack at the back of the room and monitor 3(via DVI) on it's right.
When in discussion layout, we see the remote party on monitor 1 and 3 and presentation(local/remote) on monitor 2 and that's perfect.
However SpeakerTrack and PresenterTrack does not switch automatically in this mode and the remote party sees our feed split in 2 with the front and back cameras side by side.
When we choose LocalPresenter or RemotePresenter, with "PresenterTrack Enabled Status" on the switching is done automatically.
However, each time the switching occurs, we see one of the monitors stop displaying, eg for LocalPresenter mode, the remote feed appears on monitor 3 and monitor 1 stays blank.
When RemotePresenter is enabled, mon 3 goes blank and mon 1 displays. This is very distracting for the presenter as they have to look back and forth.
we would appreciate to have the automatic switching but with a behavior that displays the remote feed on mon 1 and 3 at all times, similar to discussion mode.
Any help is much appreciated.
