10-05-2017 02:43 AM - edited 03-08-2019 12:16 PM
I have a modem with IPv4 and IPv6 configurations. And in my Cisco BRAS iOS server have a IPv6 configurations.
My topoly is BRAS server(DHCPv4 adn DHCPv6 server) --> L2 cisco switch --> Modem
I am configuring the modem like tagging WAN and I cannot get IPv6 from DHCPv6 server but I can get the IPv4 IP from DHCPv4 server. I have configured my port in switch as Tagged/Trunk. But I can't get IP from DHCPv6 server in tagging config.
Here is my DHCP pool config and Interface config in my server.
ipv6 unicast-routing
ipv6 source-route
ipv6 cef
ipv6 dhcp pool STATEFUL
address prefix 2001:1111:1111:1234::/64
dns-server 2001:4860:4860::8888
domain-name PRODAPT.LOCAL
!
ipv6 dhcp pool dhcpv6
prefix-delegation pool ipv6_pool1 lifetime 7200 300
address prefix 2001:470:19:417::/64
dns-server 2001:4860:4860::8888
dns-server 2001:4860:4860::8844
interface GigabitEthernet0/2.20
description VLAN 20 PPPPoE/DHCP
encapsulation dot1Q 20
ip dhcp relay information trusted
ip address 10.102.2.1 255.255.255.0 secondary
ip address 10.102.1.1 255.255.255.0
no ip redirects
no ip proxy-arp
ip accounting output-packets
ip accounting access-violations
ip nat inside
no ip virtual-reassembly
no ip mroute-cache
ipv6 address 2001:470:19:417::1/64
ipv6 enable
ipv6 dhcp server dhcpv6
pppoe enable group global
no cdp enable
arp timeout 86400
Solved! Go to Solution.