Hi,
I have an ASAv Firewall. My goal is to combine a couple of interfaces into a logical port channel.
When I enter config mode and go into an interface the channel-group command is not there.
Wondering what I'm not doing, besides not being smart ?
Andy
ASA1(config-if)# ?
Interface configuration commands:
authentication authentication subcommands
bfd BFD interface configuration commands
bridge-group Specify the bridge group that this interface is a part of
cts Configure interface specific CTS settings
ddns Configure dynamic DNS
default Set a command to its defaults
delay Specify interface throughput delay
description Interface specific description
dhcp Configure parameters for DHCP client
dhcprelay Configure DHCP Relay Agent
duplex Configure duplex operation
exit Exit from interface configuration mode
flowcontrol Configure flowcontrol operation
hello-interval Configures EIGRP-IPv4 hello interval
help Description of the interactive help system
help Interactive help for interface subcommands
hold-time Configures EIGRP-IPv4 hold time
igmp IGMP interface commands
ip Configure the ip address
ipv6 IPv6 interface subcommands
mac-address Assign MAC address to interface
management-only Dedicate an interface to management. Block thru traffic
mfib Interface Specific MFIB Control
multicast Configure multicast routing
nameif Assign name to interface
no Negate a command or set its defaults
nve-only Dedicate an interface to source-interface of a NVE. Block
thru traffic
ospf OSPF interface commands
pim PIM interface commands
policy-route Enable policy based routing
pppoe Configure parameters for PPPoE client
rip Router Information Protocol
security-level Specify the security level of this interface after this
keyword, Eg: 0, 100 etc. The relative security level between
two interfaces determines the way the Adaptive Security
Algorithm is applied. A lower security_level interface is
outside relative to a higher level interface and equivalent
interfaces are outside to each other
shutdown Shutdown the selected interface
speed Configure speed operation
split-horizon Configures EIGRP-IPv4 split-horizon
summary-address Configures EIGRP-IPv4 summary-address
zone-member Associate interface to a zone
