I want to start Trex on 8 ports and while starting the trex, i am observing below error:
Number of ports found: 8
wait 10 sec ..........
port : 0
------------
link : link : Link Up - speed 1000 Mbps - full-duplex
promiscuous : 0
port : 1
------------
link : link : Link Up - speed 10 Mbps - full-duplex
promiscuous : 0
port : 2
------------
link : link : Link Up - speed 1000 Mbps - full-duplex
promiscuous : 0
port : 3
------------
link : link : Link Up - speed 1000 Mbps - full-duplex
promiscuous : 0
port : 4
------------
link : link : Link Up - speed 1000 Mbps - full-duplex
promiscuous : 0
port : 5
------------
link : link : Link Up - speed 100 Mbps - full-duplex
promiscuous : 0
port : 6
------------
link : link : Link Up - speed 1000 Mbps - full-duplex
promiscuous : 0
port : 7
------------
link : link : Link Up - speed 100 Mbps - full-duplex
promiscuous : 0
-------------------------------
RX core uses TX queue number 1 on all ports
core, c-port, c-queue, s-port, s-queue, lat-queue
------------------------------------------
1 0 0 1 0 2
2 2 0 3 0 2
3 4 0 5 0 2
4 6 0 7 0 2
-------------------------------
number of ports : 8
max cores for 2 ports : 1
max queue per port : 3
RING: Cannot reserve memory
ERROR there is not enough huge-pages memory in your system
EAL: Error - exiting with code: 1
Cause: Cannot init nodes mbuf pool nodes-2
