11-07-2018 11:09 PM
Hi all,
We have a customers who wants to use profiling of 2802I AP´s in ISE.
But it appears there is a difference between real life CDP info on switches compared to what we provide on profiling feed.
CDP info gathered on switch:
800 AP cdp info fra NAD:
Device ID: ARSLap016
Entry address(es):
IP address: 10.89.171.75
IPv6 address: FE80::A23D:6FFF:FE57:E48C (link-local)
Platform: cisco AIR-AP2802I-E-K9, Capabilities: Router Trans-Bridge
Interface: GigabitEthernet3/0/5, Port ID (outgoing port): GigabitEthernet0
Holdtime : 153 sec
Version :
Cisco AP Software, ap3g3-k9w8 Version: 8.5.135.0
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 2014-2015 by Cisco Systems, Inc.
Data collected in ISE:
NFO FRA ISE:
cdpCacheAddress |
10.89.171.75 |
cdpCacheCapabilities |
R;T |
cdpCacheDeviceId |
ARSLap016 |
cdpCachePlatform |
cisco AIR-AP2802I-E-K9 |
cdpCacheVersion |
Cisco AP Software, ap3g3-k9w8 Version: 8.5.135.0 Technical Support: http://www.cisco.com/techsupport Copyright (c) 2014-2015 by Cisco Systems, Inc. |
But our conditions :
We can of course create our own and we did that, but customer is wondering why the built-in profiles are incorrect and when that will be fixed??
Br
Tue Frei Noergaard
Solved! Go to Solution.