12-04-2018 10:19 AM - edited 03-11-2019 01:52 AM
Hi,
We have been running ISE 2.4 in distributed model. Recently we have added Airwatch MDM servers to ISE - connection status shows OK . I was sure that i will be able to check compliance or registration status of any device connecting to 802.1x enabled SSID (WPA2 enterprise). After couple of hours i realized that there is no correlation between 802.1x (Radius) queries and MDM HTTP calls as devices were not onboarded on ISE directly. They are on-boarded out-of-band communicating directly with Airwatch via GSM/LTE connection.
My question is: Is it possible to have such setup where devices are on-boarded independently on MDM and ISE can still check compliance status against of MDM server?
Solved! Go to Solution.